Aleph Light Engine-DB917 with a Seoul P4 U bin. The caveats will be: No specified Tint. Most of the ones we are currently using are on the warm side I've noticed that both Cree and Seoul phosphor control is not as good as Lumileds and the tint does vary quite a bit even from ones in the same batch which is more than Lumileds. As such I feel obligated to forewarn you if you are need specific tint. Since we don't really have any control along with limited stock from the Seoul we are not getting Bin code specific branding regarding the tint bins. Thus, the next batch will more than likely be a different tint code than previous. The Flux is U rank. The first two batches that are complete should work as drop in upgrades for any A1, A3 head with the stock reflector. The LED legs have been bent down directly at the plastic body to help avoid shorting the electrical contacts. You may want to paint the LED anode/cathode with nail polish to provide another level of preventative measure. The LED may not be absolutely centered dead nuts. They should fit and not have any degradation in beam with the A1, A3 head configuration. I did not test each and every one. If one is out of whack I will warranty a replacement or exchange/refund. If you have expectations above and beyond what is stated above I will not warranty any exchange/refund for tint or other minor cosmetics. That also applies for any dust bunnies that the gummy dome may have incured during assembly, packing or shipping. You take full responsibility for maintaining, cleaning of the gummy dome and no the gummy is not edible. |